Sony DCR-HC85 Marketing Operation Manual page 120

Symptom
A title is not recorded/A cassette label
is not recorded.
The title is not displayed.
The title cannot be deleted.
The Title search does not work.
Still pictures cannot be dubbed from a
tape to a "Memory Stick Duo."
Movies cannot be dubbed from a tape
to a "Memory Stick Duo."
Digital program editing on the tape
does not function.
The VCR is not responding properly
during Digital program editing when
it is connected via an i.LINK cable.
Digital program editing on the
"Memory Stick Duo" does not
function correctly.
120
Troubleshooting
Cause and/or Corrective Actions
cUse a cassette with Cassette Memory. (p. 126)
cErase unnecessary titles when the Cassette Memory is full. (p. 82)
cSet the write-protect tab to REC. (p. 126)
• A title cannot be added to a blank section of the tape.
cSet [
TITLE DISP] to [ON] in the
(p. 83)
• The title cannot be displayed during Easy Handycam operation.
cSet the write-protect tab to REC. (p. 126)
cEnter a title if there is no title on the tape. (p. 81)
cUse a cassette with Cassette Memory. (p. 126)
cSet [ SEARCH] to [ON] in the
• There is a blank section in the beginning or middle of the tape. This is
not a malfunction.
• You cannot record or a distorted picture may be recorded if the tape has
been used repeatedly for recording.
• You cannot record or a distorted picture may be recorded in the
following:
– The tape has a blank section.
– The tape has been used repeatedly for recording.
– Input signal has been interrupted or cut.
cSet the input selector on the VCR correctly, then check the connection
between your camcorder and the VCR. (p. 93)
cWhen your camcorder is connected to a DV device that is not a Sony
product via an i.LINK cable, select [IR] in step11 of "Step 1: Preparing
your camcorder and VCR for operation" (p. 98).
cAdjust the synchronization of the VCR. (p. 101)
cEnter a correct [IR SETUP] code. (p. 100)
cSelect the mode used to cancel recording pause again. (p. 100)
cSet your camcorder and the VCR more than 30 cm (12 in.) apart. (p. 100)
• The program cannot be set to a blank section on the tape.
• While connecting via an i.LINK cable, select [IR] in step 11 of "Step 1:
Preparing your camcorder and VCR for operation" (p. 98).
• The program cannot be set to a blank section on the tape.
• You cannot record or a distorted picture may be recorded if the tape has
been used repeatedly for recording.
(EDIT/PLAY) menu.
(EDIT/PLAY) menu. (p. 81)