Programming Mode - PSC SP400 Manual

P M
ROGRAMMING ODE
The scanner must be placed in Programming Mode before its configuration can be altered
using the bar codes in this guide. Enter programming mode by scanning the SET barcode at
the top of each programming set. The scanner's green light will flash continuously, indicating
the scanner is in Programming Mode.
While in Programming Mode, the scanner will recognize only specially formatted
programming bar code labels like those contained in this guide, and will not decode
bar code labels of any other type. Scan all programming bar code labels needed to set
the scanner's features to the desired settings. The scanner will beep after each bar code
label is scanned, indicating that the setting has been stored in memory. The scanner
will emit a rejection tone if a scanned bar code programming label isn't valid.
To exit Programming Mode and save all changes made during the programming
session, scan the END bar code at the bottom of each programming set. The
scanner will return to normal operation.
Disconnecting power during Programming Mode will cause the scanner to return
to its previous settings.
3
R44-1541