Rs-232 Interface Programming; The Quickscan 6000/6000 Plus Interface (I/F) Cable - PSC SP400 Manual

RS-232 I
NTERFACE
For your convenience, this guide provides minimal configuration and option
settings for your scanner's RS-232 interface. For more detailed programming
information and features, reference the SP400 Programming Guide (R44-1020) or the
QuickScan 6000/6000 Plus Programming Guide (R44-1540), available from your dealer.
T Q S
HE UICK CAN
To disconnect the I/F cable at the scanner, insert a bent paper clip or 0.050" hex
driver into the opening marked CABLE RELEASE as shown in Figure 1, and push
inward. Once the connector latch is released, continue to hold the latch in while
carefully pulling the cable free.
Connect the QuickScan 6000/6000 Plus scanner to your system using ONLY the
proper PSC approved QuickScan 6000/6000 Plus I/F cable.
Interface
Connector
Figure 1. Disconnecting/Connecting the QuickScan 6000/6000 Plus I/F Cable
R44-1541
P
ROGRAMMING
6000/6000 P
Connection using an unapproved cable can result in
damage to the scanner. QuickScan 6000/6000 Plus
cables can be identified by a cable I.D. code printed on
a white label, approximately 1" in length, attached to
them.
Paper Clip
QuickScan 6000 Plus I/F cables offer an enhanced
capability that will automatically select the host-
specific interface type when the cable is attached.
For example, a scanner attached using an RS-232
cable will automatically communicate via RS-232;
when attached using a Keyboard Wedge cable, it
will automatically communicate with a Keyboard
Wedge system.
I
LUS NTERFACE
WARNING
Approved
QS6000 Cable
NOTE
(I/F) C
ABLE
Latch
Overmolding
DO NOT use
unapproved
cables without
the overmolding
1