Codabar Fixed Length - PSC SP400 Manual

Most scanners shipped from the factory are set to read variable length labels for
Codabar. If you switch from variable to fixed length labels, the factory set fixed
label lengths are 14 and 08. Follow the steps below to change these defaults.
E F
NABLE IXED
1. Identify the fixed length settings you want to make.
2. Scan the SET label.
3. Scan the SET FIRST FIXED LENGTH label.
S L
ETTING ENGTHS
If you are setting a length less than ten, you must scan a zero first and
then the length digit (02, ...09).
4. Set the first fixed length label by scanning the correct digits
from the next page. The selectable range is from 03 to 50.
If you need to set a second fixed length, continue with step
five. If you do not need to set a second fixed length, scan
the NO SECOND FIXED LENGTH label below and skip to
step seven.
SET ----------------------------------------------
S
ET
S
ET
N
O
30
SP400/QuickScan 6000/6000 Plus RS-232 Interface Programming
C
ODABAR
F F L
IRST IXED ENGTH
S F L
ECOND IXED
S F L
ECOND IXED
F L
IXED ENGTH
---------
------
ENGTH
-------
ENGTH