Table of Contents
Advertisement
R
F
C
ETURN TO
ACTORY
ONFIGURATION
If, during a programming session, you wish to reset the scanner's configu-
ration to its original factory settings, scan the Return to Factory label
below. Use this label ONLY IF NECESSARY, since it will reset any
changes made to this interface during any previous programming session.
RETURN TO FACTORY
P
M
ROGRAMMING
ODE
The scanner must be placed in Programming Mode before its configura-
tion can be altered using the bar codes in this guide. Enter programming
mode by scanning the SET label found at the top of each label set. The
scanner's green light will flash continuously, indicating the scanner is in
Programming Mode.
While in Programming Mode, the scanner will recognize only specially
formatted programming bar code labels like those contained in this guide,
and will not decode bar code labels of any other type. Scan all program-
ming bar code labels needed to set the scanner's features to the desired
settings. The scanner will beep after each bar code label is scanned,
indicating that the setting has been stored in memory. The scanner will
emit a rejection tone if a scanned bar code programming label isn't valid.
To exit Programming Mode and save all changes made during the pro-
gramming session, scan the END label located at the bottom of each label
set. The scanner will return to normal operation.
Disconnecting power during Programming Mode will cause the scanner to
return to its previous settings.
3
R44-1542
Advertisement
Table of Contents
