Table of Contents
Advertisement
Most scanners shipped from the factory are set to read variable length
labels for Codabar. If you switch from variable to fixed length labels (by
disabling variable lengths on the previous page), the factory set fixed label
lengths are 14 and 08. Follow the steps below to change these defaults.
E
F
NABLE
IXED
1. Identify the fixed length settings you want to make.
2. Scan the SET label.
3. Scan the SET FIRST FIXED LENGTH label.
S
L
ETTING
ENGTHS
If you are setting a length less than ten, you must scan a zero first and
then the length digit (02, ...09).
4. Set the first fixed length label by scanning the correct digits
from the next page. The selectable range is from 03 to 50
If you need to set a second fixed length, continue with step
five. If you do not need to set a second fixed length, scan
the NO SECOND FIXED LENGTH label below and skip to
step seven.
SET
-------------------------------------
S
ET
S
ET
N
O
1
The scanner will decode up to 50 characters, but the actual length read will vary
depending upon bar code size and quality. The IBM POS interface is limited to 32
character labels.
2 8
SP400/QuickScan 6000/6000 Plus Keyboard Wedge I/F Prog
C
ODABAR
F
F
L
IRST
IXED
ENGTH
S
F
L
ECOND
IXED
S
F
L
ECOND
IXED
ENGTH
F
L
IXED
ENGTH
------
----
ENGTH
-----
1
.
Advertisement
Table of Contents
