Adding The As-Interface Master Modules To The Simotion Project - Siemens SIMOTION Function Manual

Configuring

5.2 Adding the AS-Interface master modules to the SIMOTION project

4. Assign device names according to the rules for address and name assignment in the
SIMOTION system (see:
5. Parameterize the IE/AS-Interface Link PN IO AS-Interface master module and the AS-
Interface slaves in HW Config. For a detailed description of parameterizing the module,
see:
–
– Documentation for the corresponding AS-Interface slaves
Centralized use of the CP 343-2 P AS-Interface master module (for SIMOTION C2xx only)
1. To configure the mechanical design, and prepare and install the SIMOTION components
for assembly, see:
–
–
2. To continue, refer to steps 5. to 7. for distributed use with PROFIBUS.
Note
The listed documents are included in the SIMOTION SCOUT scope of supply as electronic
documentation
5.2 Adding the AS-Interface master modules to the SIMOTION project
Requirements
The following requirements must be met when networking with PROFIBUS:
1. You have created a project in SIMOTION SCOUT and have inserted a rack with a
SIMOTION hardware platform in the hardware configuration.
2. You have configured a PROFIBUS subnet (for distributed use only).
Note
For how to create a project and configure a PROFIBUS subnet, refer to the online help of
SIMOTION SCOUT.
30
SIMOTION SCOUT Communication System Manual.
SIMATIC NET IE/AS-Interface Link PN IO Manual.
You can use the "Upload to PG" function to import the configuration of the AS-
Interface slaves into your hardware configuration.
SIMOTION C Operating Instructions
SIMATIC S7-300 Automation System, Hardware and Installation Software Installation
Manual.
Extension to the command interface for AS-Interface master modules
Function Manual, 01/2015