Sony DCR- TRV24E Operating Instructions Manual page 105

Dubbing only desired scenes
– Digital program editing (on
tapes)
Step 1: Connecting the VCR
You can connect both the A/V connecting cable
and the i.LINK cable (DV connecting cable).
When you use the A/V connecting cable, connect
the devices as illustrated on page 100. When you
use the i.LINK cable (DV connecting cable),
connect the devices as illustrated on page 102.
If you connect using the i.LINK cable (DV
connecting cable)
With a digital-to-digital connection, video and
audio signals are transmitted in digital form for
high-quality editing.
Step 2: Setting the VCR to
operate with the A/V
connecting cable
To edit using the VCR, send the control signal by
infrared rays to the remote sensor on the VCR.
When you connect using the A/V connecting
cable, follow the procedure below, (1) to (4), to
send the control signal correctly.
(1) Set the IR SETUP code
1 Set the POWER switch to PLAYER*
on your camcorder.
2 Turn the power of the connected VCR on,
then set the input selector to LINE.
When you connect a video camera recorder,
set its power switch to VCR/VTR.
3 Press MENU. Select VIDEO EDIT in
the SEL/PUSH EXEC dial
(p. 242).
* 1) DCR-TRV16E/TRV18E/TRV24E only
2)
* DCR-TRV25E/TRV27E/TRV116E/TRV118E
only
1) 2)
/VCR*
with
(1)
1
2
3
1)
2)
1
2
1) 2)
(1) (4)
105