Programming Commands; Connection To Device - Datalogic Matrix N Series Manual

2

2 PROGRAMMING COMMANDS

2.1 CONNECTION TO DEVICE

DESCRIPTION
1 Enter Host Mode
After entering this command, the device responds with the first reply message and
then waits for the following command.
2 Enter Programming Mode
After entering this command, the device responds with the second reply message.
Now you can send one or more programming strings as shown in Chapter 3.
3 Exit Host Mode
This command must always be transmitted to end the programming session.
The configuration job management depends on the commands issued prior to exit
from Host Mode. See 3.2 for more details.

If the SAVE command was issued before exit from Host Mode, the job is saved
in permanent memory (Flash).

If the SAVE command was not issued before exit from Host Mode, the job is
saved in temporary memory (RAM).
4
MATRIX N FAMILY HOST MODE PROGRAMMING
HOST COMMAND
<ESC> [ C
<ESC> [ B
<ESC> [ A
REPLY MESSAGE
<ESC> H <CR><LF>
<ESC> S <CR><LF>
<ESC> [ X