Sony Handycam CCD-TRV238E Operation Manual page 71

8
Press the SEL/PUSH EXEC dial.
The ending point of the first program is set,
and the lower part of the program mark
changes to light blue.
0 : 09 : 07 : 06
VIDEO EDIT
MARK 2 IN
UNDO
ERASE ALL
START
EDIT SET
TOTAL 0 : 00 : 12 : 00
SCENE 1
[ MENU ] : END
9
Repeat steps 5 to 8 and create
programs.
10
Set your VCR to the recording pause.
Skip this step if your camcorder is
connected via an i.LINK cable.
11
Turn the SEL/PUSH EXEC dial to
select [START], then press the dial.
0 : 09 : 07 : 06
VIDEO EDIT
MARK ENGAGE
UNDO REC PAUSE
ERASE ALL
START RETURN
EDIT SET EXECUTE
TOTAL 0 : 00 : 12 : 00
SCENE 1
[ MENU ] : END
12
Turn the SEL/PUSH EXEC dial to
select [EXECUTE], then press the dial.
A search for the beginning of the first
program starts, then the recording starts.
[SEARCH] appears during search and
[EDITING] appears during editing.
0 : 00 : 06 : 00
V I DEO ED I T
EDITING
SCENE 1 / 1
[ ] : CANCEL [ MENU ] : END
When a program is recorded, the program
mark stops flashing and remains lit. When
all programs have been recorded, the
program editing operation stops
automatically.
To cancel recording, press
To end Digital program editing
Press MENU.
To save a program without using it to
record
Press MENU in step 11.
The program is stored in memory until the
cassette is ejected.
To erase programs
1
Follow steps 1 to 4 in "Recording the
selected scenes as programs" (p. 70).
2
Turn the SEL/PUSH EXEC dial to select
[UNDO] or [ERASE ALL], then press
the dial.
When you select [UNDO]
You can erase the last set program.
When you select [ERASE ALL]
You can erase all the programs.
3
Turn the SEL/PUSH EXEC dial to select
[EXECUTE], then press the dial.
The programs are deleted. To cancel this
operation, select [RETURN], and then
press the dial.
b Notes
• You cannot set starting point or ending point on a
blank section of the tape. If there is a blank section,
the total time may not appear correctly.
• When you cannot operate the device correctly using
an i.LINK cable connection, select [IR] in step 9 on
p. 68, and set the [IR SETUP] code.
(stop).
71
Dubbing/Editing