Installing The Battery Pack - Sony Handycam CCD-TR2300 Operating Instructions Manual

Charging and installing the battery pack
To remove the battery pack
Slide the battery pack in the direction of the arrow.
Notes on charging the battery pack
• The CHARGE lamp will remain lit for a while even if the battery pack is removed
and the power cord is unplugged after charging the battery pack. This is normal.
• If the CHARGE lamp does not light, disconnect the power cord. After about one
minute, reconnect the power cord again.
• You cannot operate the camcorder using the AC power adaptor while charging the
battery pack.
• When a fully charged battery pack is installed, the CHARGE lamp will light once,
then go out.

Installing the battery pack

Align the grooves of the battery pack with the receptacles of the camcorder and slide
the battery pack down until it catches on the battery release lever and clicks.
To remove the battery pack
While pressing BATT (battery) PUSH, slide the battery pack in the direction of the
arrow.
8
AC-V315 AC-V316/V316A
BATT PUSH
CCD-TR2300/TR3300 3-856-204-23 (1)