Noise / Vibration; Technical Specifications - wurth ESS 115-2 Original Operating Instructions

Dust extraction (fig. III)
Internal dust extraction:
Push the dust collector [5] onto the appropriate
■
connection piece [12] until it snaps into place.
For removal, pull off the dust collector [5].
■
Note
For best dust suction performance,
empty the dust collector [5] in a timely
manner and clean the fold filter [11].
External extraction:
During woodworks or processing material
■
during which harmful dust is generated, the
device must be connected to a suitable external
extraction equipment (e.g. Würth vacuum
cleaner).
Maintenance / care (fig. III)
Important!
The device may only be cleaned with
the mains plug disconnected.
Remove dust collector
Open the access flap [10].
■
Empty the dust collector [5].
■
Remove the fold filter [11].
■
Tap the filter or remove the dust with a soft
■
brush.
Note
You can also flush the fold filter [11]
with fresh water (dry before insertion!).
Inserting a dust collector
Slide the fold filter [11] into the lateral guide.
■
Note
Clean the device regularly!
Simultaneously clean the ventilation
slots with a vacuum cleaner.
Renewing a worn grinding plate
Unscrew the fastening screw.
■
Remove the grinding plate.
■
Attach the new grinding plate.
■
Drive in fastening screws
■
(tightening torque = 3.5 Nm +/- 0.2 Nm).

Noise / vibration

The measured values conform to EN 60 745.
Typical measured noise levels (A): Sound pressure
level 79 dB (A); sound power level 90 dB (A).
The rated acceleration is typically 3.7 m/s

Technical specifications

Item
Dimensions L x W
Rated input power
Power output
Speed in no-load mode
(setting wheel)
Vibration in no load
mode (setting wheel)
Oscillating circuit diam-
eter
Weight without cord
Protection class
.
2
5707 700 X
112 x 230 mm
350 W
180 W
4,200 - 9,200 rpm
8400 - 18.400 rpm
2,2 mm
2,7 kg
II
11