H3C S9500 Series Operation Manual page 32

Operation Manual – VRRP
H3C S9500 Series Routing Switches
# Configure VLAN 2.
<SwitchB> system-view
[SwitchB] vlan 2
[SwitchB-vlan2] port ethernet 1/5
[SwitchB-vlan2] quit
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.128
# Create VRRP group 1 and configure its virtual IP address as 202.38.160.100.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.100
[SwitchB-Vlan-interface2] quit
# Configure VLAN 3.
[SwitchB] vlan 3
[SwitchB-vlan3] port ethernet 1/6
[SwitchB-vlan3] quit
[SwitchB] interface vlan-interface 3
[SwitchB-Vlan-interface3] ip address 202.38.160.131 255.255.255.128
# Create VRRP group 2 and set its virtual IP address to 202.38.160.200.
[SwitchB-Vlan-interface3] vrrp vrid 2 virtual-ip 202.38.160.200
# Set the priority of Switch B in VRRP group 2 to 110.
[SwitchB-Vlan-interface3] vrrp vrid 2 priority 110
3) Verify the configuration
You can use the display vrrp verbose command to verify the configuration.
# Display detailed information of the VRRP group on Switch A.
[SwitchA-Vlan-interface3] display vrrp verbose
IPv4 Standby Information:
Run Method
Virtual IP Ping : Enable
Total number of virtual routers: 2
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
Interface
VRID
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 110
: YES
: NONE
: 202.38.160.100
: 0000-5e00-0101
: 202.38.160.1
: Vlan-interface3
: 2
1-31
Chapter 1 VRRP Configuration
Adver. Timer : 1
State : Master
Run Pri : 110
Delay Time : 0
Adver. Timer : 1