Fujitsu PRIMERGY RX600 S3 Start Manual page 5

9
Click[Prepare & initiate an unattended
installation of (OS)].
The guided mode for the selected OS starts up.
10
Click [Start here to create a complete
configuration file].
The [Open ServerStart Configuration File] window
appears.
11
Select the configuration file and click
[Create].
The wizard starts up automatically.
12
Set the server information.
Click the wizard sequentially, and enter the server
information.
Clicking [help] under the wizard window displays
explanations of items and setting hints.
1. (OS) Install wizard
Set the computer information, user infor-
mation, network protocol, etc.
2. Application wizard
It is recommended to install the application
selected as default.
8
Turning off the power and installing optional devices
Install optional devices to be installed after the OS installation.
"Chapter 7 Installing Internal Options"
1
Check that no medium is inserted in the
floppy disk drive or CD-ROM drive.
2
Exit the operating system (OS).
After the OS is exited, the server is au-
tomatically turned off.
When the server is not turned off after the OS is
exited, press the power switch on the front of the
server.
3
Turn off the power supply of the periph-
eral devices, such as the display.
4
Install the optional devices.
13
Click [Close and save Configuration
File].
Click [Save As] and save the configuration file.
14
Click[Click here, to Start the Installation
of (OS)].
The license window appears.
Follow the window instructions.
Incorrect settings will cause errors to be displayed.
Enter correct values manually to continue the pro-
cess.
15
When a message indicating installation
completion appears, press any key.
16
Restart the system.
Click [Start] - [Shutdown]. Select [Restart] and
click [OK].
17
When the system restarts, log on to
the server using the Administrators
account for the local computer.
18
Set an administrator account for the
RAID management tool (ServerView
RAID).
The user account of Windows is required when
using ServerView RAID. Create the group
adm and create an account with any name for
",
an administrator of the array in the same group.
For details, refer to the manual in the Array Con-
troller Document & Tool CD.
After optional devices are installed, set the BIOS
Setup Utility as required. For details, refer to the
"User's Guide Chapter 8 Configuring Hardware and
Utilities".
If an UPS device is installed, set the BIOS Setup
Utility as required. For details, refer to the "User's
Guide 5.5.4 Notes on Advanced Uninterruptible
Power Supply (UPS)".
When turning on the server again after turning it
off, wait for at least ten seconds and then press the
power switch.
If the server is turned on straight after being turned
off, an error will occur and may cause damage.
5
raid-
"