Screen Settings And Mapping Your Lawn - Bosch Indego Installation Manual

If you have a connected model the setting can be
configured using the app. You can download the
Bosch Smart Gardening app by scanning the QR
code A here:
Screen settings and
6
mapping your lawn
To operate your Indego ensure the on/off switch is turned on at the back of
the mower and press the key. The screen will switch on after a few seconds.
Follow the on-screen instructions or instructions on the App for connected models.
The up ▲ or ▼ down keys allow you to choose an option within a menu screen.
The left ◀ and right ▶ keys allow you to go through the menu options.
The key will take you to the previous menu screen.
The key will confirm the selection or take you to the following screen in the menu.
"Set Language"
6.1
Set time and date.
6.3
40
Indego app
Download
A
Choose your PIN code.
6.2
Keep the PIN code secret from third parties.
The mower will not work without your PIN code.
▶ If you have lost your PIN code, the PIN needs to be reset.
▶ If you own a connected model, you can do this via the app.
▶ If you own a non-Connected mower, you can recover your PIN
via the "MyBosch" website MyBosch-Tools.com.
▶ To use this service, you need to register your
Indego at "MyBosch".
Please make a note of your
PIN code here:
Mapping the garden
6.4
Type A
Press the key to map the garden.
The blades do not rotate when the machine follows the wire during mapping. Whilst mapping your Indego will follow the
wire around the edge of the lawn area. Mapping is complete when the machine touches the docking station. Confirm this on
the screen when prompted. Then the mower will drive back for a few meters to enter the docking station.
Note: walk alongside Indego while it is following the edge.
Type B
During the mapping, Indego will not follow the wire leading to the additional area. This area will not be mapped.
The additional area will not be included in the calculated lawn size displayed in the "my lawn" section of the App.
Your Indego will navigate the additional area in a random mowing pattern. Areas with a docking station are cut in parallel
lines using Logicut Intelligent Cutting.
Type C
After mapping the first garden, carry the mower to the next garden.
Place the mower into the additional docking station. Make sure the mower and the docking station are switched on and
press the key. Mower displays "Map Now".
After the mapping has been completed, the mower will return to the docking station and will save the map.
Now your Indego is able to navigate the lawn, cutting the grass in parallel lanes.
If you have a 3 garden with a docking station, repeat the process.
rd
Mapping excluded objects
6.5
During the mapping, excluded objects will not be mapped. Mapping of the objects will happen during the first 3 cutting
sessions. When the Indego encounters an object that has been excluded, using the perimeter wire, it will follow it around
to establish its shape.
Your Indego will then drive to the outer perimeter wire and follow it until it has confirmed the location of the object. It may
return to the docking station.
The newly discovered object will be saved automatically in the map.
This process will be repeated with every object.
Set the height of cut for the grass.
6.6
It is recommended to start at a higher setting and then gradually
reduce the level as the the wire disappears under the grass.
This will prevent your Indego cutting the wire.
Note: the Indego is designed to cut small pieces of
grass (5 mm) that drop down and fertilise the soil.
GB
41