Intended Use; Package Content; System Requirements; Technical Data - GRAUPNER Sim-Control 6 Manual

Intended use

Package content

System requirements

Technical Data

4 - 8
The Graupner Sim-Control 6 is a six channel controller that can be
connected to a PC by USB cable to use flight simulators, as
Reflex XTR, G3-G4.5, APD and Phoenix RC. The Graupner
Sim-Control 6 is suitable for airplane, glider, copter and helicopter
models simulators.
Other uses are not allowed. For any improper use no warranty
or liability is accepted.
There are two different stick function configurations available.
(Mode1, Mode 2)
Read through this entire manual before you attempt to install or
use the Sim-Control 6.
Graupner/SJ constantly works on the development of all prod-
ucts; we reserve the right to change the item, its technology and
equipment.
 Sim-Control 6 with USB cable
 Manual
Minimum hardware requirements for your PC:
 Intel Pentium 600 or higher
 32MB GAP 3D hardware accelerated graphics board
 128MB RAM
 10 GB free hard-disk memory
 52X CD-ROM
Number of controls
Model types
DSC port
Current source port
Supported simulators
USB cable length
Current consumption
Dimensions
Weight
6
Plane / glider / heli
USB PPM
USB 5 V
Reflex XTR, G3-G4.5, APD,
Phoenix RC
1 meter
26 mA
180 x 220 x 70 mm
526 grams
33006_jh_V1