Franklin Electric INLINE 1100 SPECPAK Owner's Manual page 6

Once the pilot holes have been drilled and the lag screws have been installed as per Figure 1, lift the Base Module unit and hang the unit on the lag

screws . Tighten the screws fully to secure the unit .

For installing a TRIPLEX or QUAD package, mount the Base Module Package first . The Extension Module is designed to be installed to the left of the Base

Module Package . Place a 3" Victaulic flex coupling on the left end of the Base Module manifolds, drill pilot holes for the screw locations supporting the

Extension Module, and install the lag screws leaving approximately ¼" space between the screw head and the wall . Lift the Extension Module onto the

screws and then link the manifolds by tightening down the Vic coupling . Once the manifolds are attached, tighten down all of the lag screws .

2. Header End Cap Installation

1 . Discharge End Cap Header – This end cap piece is equipped with the bladder tank and a 1-1/4" open threaded port and is configured for

installation on the left end of the discharge header . If the end cap is to be installed on the right end, the bladder tank can be easily moved to

the open 1-1/4" port . Attach the Discharge End Cap Header to the discharge header using a 3" Victaulic flex coupling .

2 . Suction End Cap – Attach this end cap to the opposite side of the suction header from the incoming site water connection using a 3" Victaulic flex coupling .

Figure 2

36.13 in QUAD ONLY

25.13 in TRIPLEX ONLY

DISCHARGE HEADER

CONNECTION POINT TO

SYSTEM PIPING

(REFERENCE POINT FOR LAG

BOLT LOCATIONS)

DRILLING LOCATION

FOR LAG BOLTS

(8 FOR DUPLEX, 12 FOR

TRIPLEX, 16 FOR QUAD)