Oxy Heli 5 Instruction Manual page 40

Tail Servo Assembly
Tail Push Rod Assembly
page 40
2 x M2.5x6 Hex Cap Screw
loctite 243
4 x M2.5x8 Hex Cap Screw
2 x STD Servo Tab
With Rudder Stick centered
and the Tail Servo Arm in the
center position, adjust the
Tail Push Rod length until the
Tail Bell Crank and Tail Case
Plate are parallel as shown.
The Oxy 4 Tail System has
approximately 3.5 of counter
torque with the Tail Bell Crank
set per instructions.
Arm position with
centered Rudder stick.
Chapter 14: Servo & Servo Rod installation
Leveler
( Accessories Bag )