Oxy Heli 5 Instruction Manual page 33

Anti Rotation Arm Assembly
Important Note:
( Box3/bag 25 ) this part, for tuning reasions,
comes factory pre assembled,
it's ready to use.
Follower Arm
2.5x4.5x4.5 Busing
2 x 2.5x6x2.6
Flange Bearing
Center Hub
Important note:
This part comes pre assembled
WITHOUT thread lock. It MUST
be re-assembled with thread
lock as shown.
page 33
M2.5x18 Hex Cap Screw
loctite 648
Important Note:
This part comes pre assembled WITHOUT
thread lock. Follow the instruction for final
assembly.
Step face to bearing
Oring 7.5W3.5 70 Shore
8x12x0.1 Shim
A
2.6x4x0.5 Washer
loctite 243
2.6x4x7 Bushing
2 x 2.5x6x2.6
Flange Bearing
add grease
11x14x1 Spacer
Chapter 11: Main Rotor Assembly
2 x PL Linkage Ball
Right Hand Thread Position
( Short Shoulder )
Turnbuckle Pitch Rod
Left Hand Thread position
( long shoulder )
Fine Adjust Shims:
In order to give fine adjustment options,
the extra Hardware Bag contains extra
Shims 8x12x0.1. Start assembly
with one (each side)pre installed shim.
If the Main Grips have
sideway play, add shims as required.
Each Grips must have the same number
of shims. If you add one shim on the left
side, you need to also add one shim on
the right side
8x12x1.5 Washer
M6x10 Button Screw