Temperature Controls
The temperature display shows the actual
temperature of the freezer and fresh food
compartments. The actual temperature will vary
from the set temperature based on factors such as
frequency of door opening, amount of food, defrost
cycling and room temperature.
NOTE: Frequent door openings or a door left open
for periods of time may increase the internal
temperature of the freezer and fresh food
compartments temporarily.
and fresh food compartments, press either "+" pad
until both displays show OFF.
To turn the cooling system on, press either "–" pad.
The preset temperatures of 0°F and 37°F will appear
in the displays.
To check the current temperature setting for the
fresh food or freezer compartment, press the "+" or
"–" pad once. After 5 seconds, the display will return
to the actual temperature.
To change the temperature settings, press the "+"
or "–" pads to the desired temperature set point for
fresh food and freezer separately. Allow 24 hours for
the refrigerator to reach the temperature that has
been set.
Temperature Range
Low
Fresh Food
34°F
1°C
Freezer
–6°F
–21°C
NOTE: Setting the controls to OFF stops cooling, but
Operating Instructions
in both the freezer
High
41°F
5°C
6°F
–14°C
– 10 –
Changing Display Temperatures from °F to
°C Installation
To change the temperature display between
Fahrenheit and Celsius, press Temp °C/°F.
Door Alarm
To turn the Door Alarm feature on, press the pad
press the pad again.
and beep if the door is kept open for more than two
minutes.
Sabbath Mode
To set Sabbath Mode, press and hold the
refrigerator "+" pad and the Temp C°/F° pad at the
same time and hold for 5 seconds. The temperature
display will show "SA" for 5 seconds, and then the
Sabbath Mode, press and hold the refrigerator "+"
pad and the Temp C°/F° pad at the same time for
DISPLAYS, ALARMS and LIGHTS: The main
temperature control, door alarms and lights will be
disabled.
ICEMAKER: The icemaker will be disabled in Sabbath
Mode.
Need help?
Do you have a question about the Monogram ZIPS360NHSS and is the answer not in the manual?
Questions and answers