Water Filter Cartridge - GE Monogram ZIPS360NHSS Technical Service Manual

Water Filter Cartridge

panel at the top of the refrigerator. Lift up the panel
to access the cartridge.
When to Replace the Filter
be replaced when the status light
turns red or if the ice cubes are
getting hollow or small.
Filter Cartridge Installation
1. Raise the grille panel at the top of the
refrigerator.
2. Remove the old cartridge by slowly turning it to
the left. A small amount of water may drip down.
Do not pull down on the cartridge.
3. Fill the new cartridge with water from the
installation.
4. Line up the arrow on the cartridge with the
center of the holder. Do not push it up into the
holder.
5. Slowly turn it to the right until the cartridge
stops. It will rotate about 1/4 turn.
DO NOT OVERTIGHTEN!
IMPORTANT NOTE
immediately stop any water leak from the Icemaker/
removed and will prevent further leaking.
Cartridge
Holder
Water Filter
To Reset the Filter Status Light
Press and hold the RESET pad for 3 seconds.
Filter Bypass Plug
1. If there is a household reverse osmosis water
system and/or another form of home water
OR
2. If
The bypass plug and the mini manual are located in
the top machine compartment.
The
Filter
Bypass
Plug
system, GE recommends the use of GE branded
in GE and Hotpoint® refrigerators provides optimal
performance and reliability. GE branded SmartWater
standards for safety and quality that are important
Hotpoint refrigerators and there is no assurance
quality, performance and reliability.
United States, visit our Website at GEAppliances.
com, or call GE Parts and Accessories,
800.626.2002.
Customers in Canada should consult the yellow
pages for the nearest Mabe Service Center.
– 44 –
must be used: