Blodgett CTB Installation Manual page 4

OVEN ASSEMBLY
ASSEMBLY TO STAND - CTB ONLY SINGLE SECTION
1. Place the assembled stand in the location where the oven is going to be used.
2. Remove the side control compartment cover and open the front control panel of a single oven (or lower section).
3. With a tool, punch out the knock-outs in the oven bottom near each corner on the control side.
4. Set the oven on the stand. Center it to the frame.
5. Align the front, and rear bolt holes of the oven with the bolt holes in the stand.
6. Insert a bolt and washer, from the top down through each of the 2 holes.
7. Place a nut and washer on each of the 2 bolts, and tighten securely.
8. Replace the oven's side control compartment, and close the front control panel.
NOTE: For single section ovens only. For double stacked ovens step 8 will be completed once the ovens are stacked.
ELECTRIC CONVECTION OVENS
Control compartment
Figure 3
4
Motor
compartment
INSTALLATION