Table of Contents
Advertisement
CONFIGURATOR SOFTWARE SETTING
With configurator software, settings shown below are available.
Refer to the software manual of R3CON for detailed operation.
■ WIRED SETTING
ITEM
Communication timeout
■ MODBUS SETTING
ITEM
Address
Data Mode
Baud rate
Parity
Write enable port
Slave or Relay
■ WIRELESS SETTING
ITEM
PAN-ID
Radio channel number
Short address
Network name
Encryption key
Transmitter power output
Communication timeout
Number of devices in a network
Packet filtering
Filter timeout on polling (100msec)
Fixed route
Destination short address
Temporary detour
Low speed moving mode
Set network quality
Network join mode
Retry times before route switching
SETTING RANGE
2 – 32000 (100 msec.)
SETTING RANGE
1 – 247
RTU / ASCII
38.4 kbps / 19.2 kbps / 9600 bps / 4800 bps
Odd / Even / None
RS-485 / wireless
Slave / Relay
SETTING RANGE
0000 to FFFE (hexadecimal, 4 digits)
0 (invalid), 1 to 43 (selectable up to 10 channels)
0000 (invalid), 0001 to FFFD (hexadecimal, 4 digits)
English one-byte characters within 16 characters
(one-byte space, "-", "_", ".", "@" are usable.)
0000...0 to FFFF...F (hexadecimal, 32 digits)
0.16 mW / 1 mW / 20 mW
0 to 32767 (100 msec.)
1 – 30 (devices) /
31 – 60 (devices) /
61 – 100 (devices) /
Fixed + Low speed movement
Disable / Enable
10 to 600 (100 msec.)
Disable / Enable
0000 to FFFD (hexadecimal, 4 digits)
Disable / Enable
Disable / Enable
Standard / Changing frequency • delaytime middle /
Changing frequency • delaytime large
V3-compatible mode / Fast join mode
1 to 3 (times)
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
R3-NMW1F
DEFAULT
30 (100 msec.)
DEFAULT
1
RTU
38.4 kbps
None
RS-485
Slave
DEFAULT
0000
0
0000
Blank
0000...0
20 mW
30
1 – 30
Enable
10
Disable
0000
Enable
Disable
Standard
V3-compatible mode
3
EM-8286 P. 4 / 10
Advertisement
Table of Contents
