Cisco MX300G2 Manual page 12

Apply the in-room control panel to the video system
Table of contents
(Not available when using the offline editor. Instead, you should export the in-
room control panel to a file in order to save your work for later.)
Introduction
Apply the in-room control panel to the video system. You will see the results
immediately on the Touch 10.
• Choose
Create a user interface Create a user interface
API for in-room control
Check the result on Touch 10
(Not available when using the offline editor.)
Widgets
Tap the in-room control icon (light bulb or generic utility icon) in the Touch 10
status bar to open the in-room control panel.
Command reference
Troubleshooting
Tips and tricks
Examples
Which in-room control icon to display is defined under
you change to the other icon, you have to export the in-room control panel to
the video system again.
D15358.01 APRIL 2016
Collaboration Endpoint software
version 8.1
© 2016 Cisco Systems, Inc.
All rights reserved.
Export > To codec
Export the in-room control panel to file
Export the in-room control panel to a file, which can be imported back into the
editor at a later stage.
• Choose
If you are using the offline editor, this is the only way you can save your work for
later.
Exporting to file may also be useful as a way of creating a design template if you
are going to push the same in-room control panel to multiple video systems.
Files exported while connected to a video system are in the same format as
files exported from an offline editor. This means that any of these files can be
imported into an editor launched from a video system's web interface, and then
pushed to the video system's Touch 10.
In-room control icon
Settings in the editor. If
12
Export > To file