Planet Networking & Communication GS-2240-48T4X Command Manual page 13


Configuring IP Address
3. At the "#" prompt, enter the following command and press <Enter>.as shown in Figure 3-3.
# configure terminal
(config)# ip route 0.0.0.0/0 192.168.1.254
(config)# interface vlan 1
(config-vlan1)# ip address 192.168.1.100/24
The previous command would apply the following settings for the Industrial Managed Switch.
IP Address: 192.168.1.100
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.254
4. Repeat step 1 to check if the IP address is changed.

Store current switch configuration
5. At the "#" prompt, enter the following command and press <Enter>.
# copy running-config startup-config
If the IP is successfully configured, the Industrial Managed Switch will apply the new IP address setting immediately. You can
access the Web interface of the Industrial Managed Switch through the new IP address.
If you are not familiar with the console command or the related parameter, enter " ?" anytime
in console to get the help description.
Figure 3-3: Configuring IP Address Screen
Figure 3-4: Saving Current Configuration Command Screen
-13-
Command Guide