Smart Lights - Blaupunkt Q Series Manual

2.2.1.4 Smart Lights

The Q & Q-Pro panels are compatible with ZigBee smart lights such
tint. Other Zigbee smart lights brands might also be compatible but have not been tested by Blaupunkt and
complete compatibility cannot be assured.
The smart light must not be paired or connected to any other panel or HUB (Phillips HUB included). If the
smart light is paired to other panel or HUB, please perform a factory reset on the smart light.
NOTE:
To factory reset a Muller Licht Tint smart lights connect the Tint bulb to the AC. Then turn it ON / OFF 5
times until the bulb starts blinking.
Phillips HUE smart lights cannot be factory reset, please use only new Phillips HUE smart lights. Do not
use Phillips HUE bulbs that belong to a kit. Phillips HUB is not compatible.
1. At the left menu click on settings and enter your
pre-set Master Code. (default master code 1111).
2. Click on devices and press the (+) icon at the top
right corner to access the "Add Device" function.
4. The panel will detect the Zigbee smart light and
will emit a double beep tone. The web interface
will display the Zigbee smart light information.
5. Check the box in front of device info, then click
OK to add the device into the panel.
12
as Philips Hue, Osram Lightify, Müller Licht
3. Connect the Zigbee smart light to the AC and
turn it ON to send a learning signal
5. Go to the automation menu at the left to manage
the smart light.
Blaupunkt Competence Centre Home Security
to the panel.