Table of Contents
Advertisement
SPECIFICATION
Model Number
Voltage
Power Output
Frequency
Suitable Temperature
CAUTION: If the "FULL TANK" indicator is on, please check if it is one of the following situations
•
Water tank is full – pour out the water and reassemble the tank
•
Water tank is not in position – pull out the tank and reassemble it
•
If the problem cannot be resolved, the unit may be out of order, please contact Customer
Services Department on 01473 271272
CONTROL PANEL
"Full Tank" – Lights up when
water tank is full. (Capacity 3L)
"On/OFF": Press to
turn unit ON and OFF,
indicator will light up
when switched on
IG9807
220V-240V
630W
50Hz
1-40°C
Wind blowing
angle indicator
Ion indicator
"Ion": Press to Start
and Stop Ioniser
function
"OSCIL": Press to
adjust the angle of
the air flow 90° / 45°
Lower / 45° Upper
Timer indicator:
1hr, 2hr, 4hr & 8hr
Mode indicator: Showing the
current working mode
"Timer": Indicates
time selected,
between 1Hr to 8Hr
"Mode": Press to switch between
different modes: Auto, Quick Dry,
Normal Dry and Eco modes
5
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IG9807 and is the answer not in the manual?
Questions and answers
How do I switch my humidifier on when the on off light is flashing and the timer lights for 1 hour and 2 hours are flashing?
If the on/off light and timer lights for 1 hour and 2 hours are flashing, the unit has likely stopped automatically after 12 hours of continuous use as a safety feature to prevent overheating. To turn the iGenix IG9807 dehumidifier back on, follow these steps:
1. Ensure the unit is plugged in securely.
2. Press the power button to restart the unit.
3. If the unit does not turn on, unplug it from the power source.
4. Wait a few minutes, then plug it back in.
5. Press the power button again to turn the unit on.
If the issue persists, check the troubleshooting guide for additional solutions.
This answer is automatically generated
the on/off light and 4hr lights are flashing and unit is beeping i have unplugged and tried again but to no avail any advice appreciated also is there some way of resetting the unit regards
If the ON/OFF light and 4-hour lights are flashing and the iGenix IG9807 unit is beeping, it indicates that the unit has been running continuously for several hours and has automatically switched off to prevent overheating. This is a normal safety feature.
To reset the unit:
1. Unplug it from the socket.
2. Wait for a short time.
3. Plug it back in and restart the unit.
This answer is automatically generated