Table of Contents
Advertisement
FEATURES
•
Compressor less dehumidifier - uses desiccant rotor technology
•
Environmentally friendly with no harmful gasses & quiet in operation
•
Moisture removal - 7 litres/day (20°C RH60%)
•
Water tank capacity - 3 litres
•
Special silver coating within the filter - kills bacteria on contact,
improving the quality of air in your home or office
•
Built-in ioniser -
•
Electronic louvre
•
Normal Dry and Quick Dry mode - includes power saving setting
for summer use & turbo setting for winter
•
Up to 8 hour timer - for added convenience
•
Temperature range for use ~ 1°C - 40°C
•
Light & portable with carry handle
•
Removable water tank with handle
•
Operating light
UNIT SET UP
•
Place the unit in an upright position on a stable, flat surface.
•
Ensure the unit is a safe distance away from a wall or furniture (minimum 20 cm from Air Inlet and
40 cm from Air Outlet)
•
Please keep clothes at a safe distance of 40 cm from air outlet of the unit to prevent water dripping
into the unit.
•
Where to position your dehumidifier?
Note: For best results position the dehumidifier somewhere central like a landing or a hallway. As long
as the internal doors are open, the excess moisture from all of the rooms in the house will migrate
naturally towards the dehumidifier and be processed.
OPERATING INSTRUCTIONS
Note: This dehumidifier will produce heat during operation; the room temperature may increase by
1°C to 4°C. If dehumidifier placed in a cabinet or a closed area, the temperature could rise >4°C.
•
Plug in the unit to the wall socket. The unit will quietly beep once and automatically switch to
Standby mode. Ensure the water tank is installed correctly, otherwise the "FULL TANK" indicator will
light up and the unit will not work.
•
Press the "ON/OFF" button and the "AUTO", "
•
Press "MODE" button to select either: AUTO, QUICK DRY, NORMAL DRY or ECO.
Auto mode: At ambient temperature of 30° below, it'll detect the relative humidity (RH) to choose its
working status as following:
A - 70%RH above, heater is at high working status; the fan is at high speed;
B - 70%~50%RH, heater is at low working status, the fan is at medium speed;
C - 50%RH below, heater is off and stops dehumidifying but runs on fan only at low speed, if the relative
humidity rises, it dehumidifies again.
6
" and OSCIL" indicators will light up
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IG9807 and is the answer not in the manual?
Questions and answers
How do I switch my humidifier on when the on off light is flashing and the timer lights for 1 hour and 2 hours are flashing?
If the on/off light and timer lights for 1 hour and 2 hours are flashing, the unit has likely stopped automatically after 12 hours of continuous use as a safety feature to prevent overheating. To turn the iGenix IG9807 dehumidifier back on, follow these steps:
1. Ensure the unit is plugged in securely.
2. Press the power button to restart the unit.
3. If the unit does not turn on, unplug it from the power source.
4. Wait a few minutes, then plug it back in.
5. Press the power button again to turn the unit on.
If the issue persists, check the troubleshooting guide for additional solutions.
This answer is automatically generated
the on/off light and 4hr lights are flashing and unit is beeping i have unplugged and tried again but to no avail any advice appreciated also is there some way of resetting the unit regards
If the ON/OFF light and 4-hour lights are flashing and the iGenix IG9807 unit is beeping, it indicates that the unit has been running continuously for several hours and has automatically switched off to prevent overheating. This is a normal safety feature.
To reset the unit:
1. Unplug it from the socket.
2. Wait for a short time.
3. Plug it back in and restart the unit.
This answer is automatically generated