Table of Contents
Advertisement
18. Do not run power cord under carpeting, or cover with rugs or
runners. Arrange the cord away from areas where it may be
tripped over.
19. Never operate or store the unit in direct sunlight.
20. To repair the unit, take it to a qualified service engineer. Repairs
carried out by unqualified people may cause damage to the unit
or injury to persons or property and void the warranty.
21. Where possible, avoid the use of an extension cable as they may
overheat and cause a risk of fire. Only use an extension cord
after ensuring it is in perfect condition.
22. Do not use the unit without the air filter
APPLIANCE OVERVIEW
Control Panel
Air outlet
4
Filter
Handle
Air Outlet Cover
Air Inlet
Water Tank Handle
Water Tank
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IG9807 and is the answer not in the manual?
Questions and answers
How do I switch my humidifier on when the on off light is flashing and the timer lights for 1 hour and 2 hours are flashing?
If the on/off light and timer lights for 1 hour and 2 hours are flashing, the unit has likely stopped automatically after 12 hours of continuous use as a safety feature to prevent overheating. To turn the iGenix IG9807 dehumidifier back on, follow these steps:
1. Ensure the unit is plugged in securely.
2. Press the power button to restart the unit.
3. If the unit does not turn on, unplug it from the power source.
4. Wait a few minutes, then plug it back in.
5. Press the power button again to turn the unit on.
If the issue persists, check the troubleshooting guide for additional solutions.
This answer is automatically generated
the on/off light and 4hr lights are flashing and unit is beeping i have unplugged and tried again but to no avail any advice appreciated also is there some way of resetting the unit regards
If the ON/OFF light and 4-hour lights are flashing and the iGenix IG9807 unit is beeping, it indicates that the unit has been running continuously for several hours and has automatically switched off to prevent overheating. This is a normal safety feature.
To reset the unit:
1. Unplug it from the socket.
2. Wait for a short time.
3. Plug it back in and restart the unit.
This answer is automatically generated