Table of Contents
Advertisement
3e-525A Wireless Access Point
You can now edit the file by adding the IP addresses of the 3e-525As
that you want to manage, each in a pair of brackets [ ].
The two files SampleRadioOn.3eti and SampleRadioOff.3eti must be
edited as a minimum. This will permit you to turn all the APs on or off
at will. You can save them to another file name if you wish (maintaining
the same file extension.) Note, if you turn all APs off and then re-enable
transmit power, be aware that the clients, which have also been turned
off, will have to be individually re-engaged, either by rebooting or by re-
inserting the PC Card.
You can customize files to control only certain APs or groups of APs.
Each AP that you group into a configuration file must have the same Ad-
min Password.
The following gives you a sample of the code that you can use from
the SampleRadioOn.3eti file.
Sample of coding in SampleRadioOn.3eti file
# This Sample Configuration file shows how to turn the radio
# to a fixed level on all units
[all]
Wireless Tx Pwr Mode:=Fixed
#For FIPS units use the following
#Gateway Access Mode:=HTTPS
#Gateway Username:=CryptoOfficer
#Each unit that you want to turn on should be listed here
#First unit
[192.168.15.1]
Wireless Fixed Pwr Level:=2
#Next unit
[192.168.15.2]
Wireless Fixed Pwr Level:=2
88
29000132-001 A
Advertisement
Table of Contents
