Configuring In Gateway Mode - 3e Technologies International 3e-525A User Manual

Table of Contents

Configuring in Gateway Mode

To configure the 3e-525A AP in gateway mode, complete the follow-

ing steps.

Open a web browser on your monitor (using Netscape Naviga-

tor 3.0 or better or Internet Explorer 4.0 or better) and type in the de-

fault IP address of the gateway on its WAN port (for example, https:

//192.168.254.254). If you have changed the LAN address of the 3e-525A

AP, then you will need to enter the LAN network address with a station

address of .1. For example if the LAN address was changed to 10.0.0,

then you would enter "https://10.0.0.1".

Then click Go on the Web browser.

You will be asked for your user name and password. You will need to

have the ID and password for the Crypto Officer role to change the mode

from access point to gateway. If that has not yet been changed, use the

default "CryptoOfficer" with the password "CryptoFIPS" to allow full ac-

cess. Click on OK and you will be directed to the System Configuration

– General page.

Using the navigation bar to the left, navigate to the System Configu-

ration — Operating Mode page, select the Gateway Mode radio button,

and click Apply. The 3e-525A AP will reboot in gateway mode and reset

all prior settings to factory default state.

29000132-001 A

Chapter 4: Configure as gateway

Table of Contents