Table of Contents
Advertisement
Ground
Wan Port
The WAN connector is used to connect the 3e-525A to the organization's
LAN. The WAN connector is routed from the unit to the power injector which
runs AC power through the Ethernet cable to the unit. The Ethernet cable is thus
run from the 3e-525A to the power injector which is then connected to a power
source and the wired LAN. A second (LAN Port) Ethernet connector is designed
for use during initial configuration only. This uses an RJ45 cable to connect the
3e-525A to a laptop. The following diagram demonstrates the setup.
Hardware Setup for 3e Technologies International's Outdoor Access Point
WAN
Ethernet
Port / PoE
110V
Power
The Indicator Lights
29000132-001 A
LAN Port
USB Port
Connect
802.11b/g
RF Antenna
for AP
LAN
Ethernet
Port
Power
Injector
Bridge Port
Connect
802.11b/g RF
Antenna for AP
Connect
802.11b/g
RFAntenna
for Bridge/
Repeater
Ethernet switch/hub
11
Advertisement
Table of Contents
