Configuring Malware Protection - Allied Telesis AR Series Technical Manual

Configuring Malware Protection

Configuring Malware Protection
This section shows an example of how to configure Malware Protection.
By default, Malware Protection is disabled and you need to explicitly enable it.
Step 1:
awplus#configure terminal
awplus(config)#malware-protection
Step 2:
awplus(config-malware)#provider kaspersky
awplus(config-malware)#protect
Step 3:
awplus#show malware-protection
Output 4: Example output from the console
awplus#show malware-protection
Status:
Provider:
Resource version:
Resource update interval: 1 hour
C613-22104-00 REV B
Enter the Malware Protection Configuration mode.
Set the provider and enable Malware Protection.
Show the information about the operation of Malware Protection.
Enabled (Active)
Kaspersky
1.0
Firewall/NAT Rules, Entities and Performance
Advanced Network Protection
|
Page 37