Configuring Anti-Virus - Allied Telesis AR Series Technical Manual

Configuring Anti-virus

Configuring Anti-virus
This section provides an example of how to configure Anti-virus.
By default, Anti-virus protection is disabled and you need to explicitly enable it
Step 1:
awplus#configure terminal
awplus(config)#antivirus
Step 2:
awplus(config-antivirus)#provider kaspersky
awplus(config-antivirus)#protect
Step 3:
By default, when a scan fails or when the limit is exceeded, the default action is deny (block). To
allow HTTP traffic when a scan fails, enter the command:
awplus(config-antivirus)#action scan-failed permit
Step 4:
awplus(config-antivirus)#do show antivirus
Output 2: Example output from the console
awplus#show antivirus
Status:
Provider:
Scan failed action:
Limit exceeded action: block
Resource version:
Resource update interval: 1 hour
C613-22104-00 REV B
Enter the Antivirus mode.
Set the provider and enable Anti-virus protection.
(Optional) Set the action to take when a scan fails.
Show the information about the operation of Anti-virus.
Enabled (Inactive Unlicensed)
Kaspersky
block
not set
Advanced Network Protection
Firewall/NAT Rules, Entities and Performance
.
|
Page 35