Infant Optics DXR-6 User Manual page 17

No sound from
Monitor Unit
Picture is black
and white
The picture
playback is not
smooth
(choppy video
with low frame
rate)
Camera Unit
power LED
changes
brightness
Noise (static, * Battery power may be too low; recharge or replace battery.
beeping)
* Possible alarm ring alert.
* Possible out of signal alert.
Noise
interference on
your Monitor
Unit
Make sure that the Camera Unit is within range of the monitor.
Confirm that the Camera and Monitor Unit are paired.
Adjust the monitor antenna to vertical position.
Volume setting may be too low. Adjust to a higher setting.
Night vision LED may be ON. Night vision mode operates in black
and white.
Turn on room lights to force monitor out of night vision mode.
Try moving the Camera Unit closer to the Monitor Unit.
Remove obstructions between the Camera and Monitor Unit.
Adjust the monitor antenna to vertical position.
Use of other 2.4GHz products, such as wireless networks (WiFi routers),
Bluetooth systems, or microwave ovens, may cause interference with
this product. Keep Camera and Monitor Unit at least 5ft (1.5m) away
from these items, or turn them off if they appear to cause interference.
This is normal. The Power LED indicator is set to dim when in the
dark, and brighten when ambient light is detected.
Volume may be set too high on the Monitor Unit. Lower volume.
The Camera and Monitor Units may be too close. Move them further apart.
The Camera Unit may be too far away and out of range. Move the
Camera Unit closer to the Monitor Unit.
Make sure the Camera and Monitor Units are placed away from
other electrical equipment, such as a television, computer or
cordless/mobile telephone.
16