Add (Pair) A Camera; View A Camera - Infant Optics DXR-6 User Manual

5.6.2 Add (pair) a camera

1. Press the MENU button and the menu bar will pop up.
2. Press the (icon) LEFT button or (icon) RIGHT button until
and the del/add/view/scan menu will pop up.
3. Press the (icon) UP button or (icon) DOWN button to select (icon) icon, and press the
OK button to confirm.
4.
button to select the desired CAM, and press the OK button to start searching for a Camera Unit.
5. Press and hold the PAIR key at the right side of the Camera Unit for at least 3 seconds. The
power LED light (green LED light, located directly below the camera lens aperture) should
flash green to indicate the Camera Units is in pairing mode. If it does not flash, press and
hold the PAIR key until the LED light flashes.
6. If unsuccessful, delete the camera channel as per 5.6.1 on page 12 and 13, and attempt to
pair again.
NOTE
A Camera Unit can only be registered to one Monitor Unit at any one time.

5.6.3 View a camera

1. Press the MENU button and the menu bar will pop up.
2. Press the (icon) LEFT button or (icon) RIGHT button until
and the del/add/view/scan menu will pop up.
3. Press the (icon) UP button or (icon) DOWN button to select (icon) icon, and press the
OK button to confirm.
4. CAM 1 / CAM 2 / CAM 3 / C
button to select the desired Camera Unit to view.
5. Press the OK button to confirm.
13
will pop up, press the
AM 4 will pop up, press the
Cam icon is highlighted,
UP button or
Cam icon is highlighted,
UP button or
DOWN
DOWN