Alarm Display - Paxton NET2 ENTRY-MONITOR Instructions Manual

Operation - Do not disturb mode

Alarm display

Dimensions
Electrical
Power over Ethernet (PoE) power rating
Communication
Ethernet bandwidth requirement
Monitors per system
Features
Screen size
Screen illumination
Screen resolution
Hands free audio
Handset audio
Environment
Operating temperature
IP Rating
Vandal resistance
Monitors should be cleaned using a clean damp cloth. Chemical cleaning products must not be used.
Visitors can be stopped from calling the monitor
by putting it into 'Do not disturb' mode.
If the screen is blank, touch the screen to display
the menu.
Touch the 'Do not disturb' option. The button will
illuminate red.
Alarm messages will display to the user at the
monitor if the option has been set in the local
Installer screen.
The user may view the camera to investigate the
alarm.
Note: Door left open alarms will only be available if
Net2 Entry is connected to a Net2 system. The Net2
system must be running v4.25 software or later.
Specifications
Width
186 mm
Min
Min
100kb/s multicast
Min
Min
0 °C
Touch the button again to
exit this mode.
Height
170 mm
Max
12.95W IEEE 802.3af class 0
Max
1Mb/s multicast per call in progress
1000
Max
4.3 inch colour TFT
Max
45 °C
Depth
45 mm
LED backlight
480x272 pixels
Two way
Two way
Indoor use only
Low
Page 8