Default Menu - Paxton NET2 ENTRY-MONITOR Instructions Manual

Operation - Viewing a camera
1. Select 'View video' mode
Where this function is permitted, the 'View video'
option will display. This allows the camera to be
used for an external view at any time.
Touch the screen to display the default menu.
Touch the 'View video' option.
2. Select the camera (if more than one)
If more than one panel is installed, this screen will
display. Use the up and down arrows to select the
required camera and touch 'Accept'.
Each camera may have the 'View video' option
enabled/disabled. The audio and open door
functions may also be enabled/disabled by the panel.
3. Viewing with the camera
The camera view will display on the monitor.
Touch the 'Hang up' option to terminate the session.
At the end of the permitted viewing time a
'Continue to view' option will display. At this point a
timer must be reset or viewing will be ended.

Default Menu

If the display is blank, touching the screen will display the Menu.
Monitor settings
QDisplays the 'Monitor settings' menu.
Do not disturb
QSee 'Operation - Do not disturb mode'.
View video
QDisplays the 'Viewing a camera' option.
Display off
QTurns off the display screen.
Page 6