Electronics Line CommPact Quick Start Installation Manual page 12

Code Authorization
Number Level
1 Master Code
2-19 Controlled
Codes
20-25 Non-controlled
Codes
26-27 Limited Codes
28 Duress Code
29 Telecontrol
Code
30 Central Station
TWA Code
32 Engineer Code
Table 8: Authorization level
To Set/Edit user code
1. Go to the main menu and press '√'.
2. Enter master code (default code '1234')
3. Select '[4] User Codes'
4. Select the code to edit and press '√'.
5. The display shows '[1] Edit Code' and Press '√'.
6. Type the new code and press '√' to confirm
7. Scroll down to '[2] Descriptor' and press '√'
8. Type user name and press '√' to confirm
Description
With the master code, you can edit all other user codes
except the Engineer code and the Central Station TWA
Code.
Caution: The default master code is 1234. Change this
code immediately after installing the system!
When you use a controlled user code for setting and
unsetting, the control system notifies the central station
with a Set/Unset event message
Non-controlled codes do not cause the system to send
Set/Unset event messages to the central station.
Valid only for 24 hours. These codes are "controlled"
Designed for situations where the user is being forced
to operate the system.
Designed to enable the user to perform a number of
tasks via their telephone when establishing remote
connection to the system via the phone.
Designed to enable the central station's operator to
establish two-way audio communication with the
Control System within ten minutes after an alarm or to
stop the bell.
The engineer code grants access to the programming
menu and the service menu.
Caution: The default Engineer code is 1111. Change
this code immediately after installing the system!
12