Ohmeda Ohio 2000 Series Operation And Maintenance Manual page 62

08/31/94
A-17
& Maintenance Manual for checkout proce-
dures.
WARNING; Perform Checkout Procedures before placing the unit in
operation.
6600-0194-000
!
Position the lower mounting bracket on the wall. Use the lower hinge
bracket as a template to mark the mounting holes on the wall for the
lower bracket.
Remove the warmer from the wall by tapping out the (2) hinge pins
from the upper bracket.
Remove the lower hinge bracket from the warmer by removing the
(2)
warmer.
Repeat steps 5, 6 and 7 to properly install the lower mounting
bracket.
Mount the warmer by inserting the back of the unit into the upper
hinge bracket mounted on the wall, then securing by tapping in the
(2) hinge pins. Secure the warmer to the lower mounting bracket by
tapping in the (2) hinge pins. Verify that the heater assembly and
side rails are rigidly secured to the wall and that the heater is level
and is parallel to the floor.
Refer to the Operation
A
3/4" Dia. Hole
Flat Washer
Slit Ring Washer
Mounting Screw
Hinge Bracket
Power Cord
Heater Assembly
10.
11.
12.
13.
14.
15.
Appendix
Figure A-5
Mounting the warmer