Ohmeda Ohio 2000 Series Operation And Maintenance Manual page 61

08131194
315Operform steps 10 through 14. For the model
3050 skip to step 15.
A-16
6600-0194-000
the proper bed-to-beater spacing.
For the model 3100 or
the wall to identify tbe attachment to
has been provided for label
(6*5 cm) will result in incorrect operation and may affect tbe
patient's condition. For your convenience, a
inches
27* 2 the specified which differs from spacing
WARNINe
Bed-to-heater
the weight of
tbe 3100 and 3150 units, approximately 75 lbs (34 kg), proper
installation will require two people.
8. Mount the warmer by inserting the back of the unit into the hinge
bracket mounted on the wall, then securing it by tapping in the (2)
hinge pins. Verify that the heater assembly is rigidly secured to the
wall, is level, and is parallel to the floor.
9. For the model 3050, attach the "proper bed to heater spacing" label
provided with the unit to the wall so that the bottom line of the label
is 29 inches (74 cm) from the lower edge of the hinge bracket.
the hinge area when installing a
wall mounted heater assembly. A pinch hazard exists.
WARNING: Heater assembly weighs approximately 30 lbs (14 kg).
Proper installation may require two people. Due to
(69+5 cm).
WARNING: Keep hands clear of
Z! Z 2 inches
l/2 screw threads must be engaged.
Verify that the bracket is level and the distance to the bed surface is
27 inches,
warmer, at least 2
5/8 inch thick drywall. For applications involving double thick-
nesses of drywall, longer screws will be required. To properly mount the
l/2 inch or
" long) are for installations in l/z - 16 UNC, 2 (3/8
.:
C
7. Mount the hinge bracket on the wall with the flat washers, split ring
washers and screws provided. See Figure A-5. Tighten the screws
with approximately 80 lb/in of torque.
Note: The screws provided
.: . .
:'
. .
.:
':
. .
.:
. .
.:
. .
.:
. .
.:
. .
4
0
0
. . . : . . . : . . . : . . . : . . . : . . . : . . . : . . . : . .
.
I
A
a
!
!
A
Toggler@ anchor
installation
Appendix
Figure A-4