Ohmeda Ohio 2000 Series Operation And Maintenance Manual page 60

08/31/94
A-15
TogglerB anchor bolts
in the wall. See Figure A-4.
A.
B.
C.
Hold the metal channel flat alongside the plastic straps and slide
the channel through the hole in the wall and track.
With one hand, hold the ring so the metal channel rests flush
behind the wall. Slide the plastic cap along straps with the other
hand until the flange of the cap is flush with the wall.
Place your thumb between the straps, and push from side to side,
snapping off the straps level with the flange of the cap.
6600-0194-000
_I__ Bed Surface
6. Perform steps A through C to secure the (4)
./
Place Bed Height
Label Here
(69+5 cm)
"f2"
the cabinet is closed.
Figure A-3
Heater to bed distance
Hinge
Bracket
Heater
Assembly
27
A
I .
WARNING: Enclosing the heater assembly inside a cabinet may
prevent proper ventilation and may create a fire hazard. If tbe
heater is enclosed in a cabinet, it must be equipped with a power
cut-off device that prevents operation while
further direction.
the hole saw miss a track do not proceed. Consult tbe
project engineer for
A
!
WARNING: When installing wall mounted units, to achieve ad-
equate structural strength all four holes must engage tracks.
Should
Appendix