Ohmeda Ohio 2000 Series Operation And Maintenance Manual page 54

08/31/94
A-9
with DISS Adapters
Two DISS vacuum adapters are mounted on a standard manifold block.
The locations of these adapters can be changed to any of the other
tapped holes in the block to meet special requirements.
Vacuum Bottle Slide Bracket
The standard vacuum bottle slide can be mounted on either upright.
Ventilator Mounting Post
The vertical mounting post is a non-locking 1 inch diameter shaft which
pivots in an 8.5 inch (22 cm) radius from the upright. One end of the
shaft extends 14 inches (36 cm) while the other extends 6.5 inches (16
cm). Ventilators, humidifiers, blenders or other user hardware can be
pivoted into optional position.
6600-0194-000
the load to 10 lbs. (4.6 kg) per drawer.
Utility Post, 22 Inch (0217-5376-800)
1 inch (2.5 cm) diameter x 22 inch (56 cm) long post
Provides a rigid vertical mounting space for stack mounting of equip-
ment. The post should be mounted as low as possible to ensure the
stability of the Warmer.
Vacuum Manifold
the unit.
Limit
cm3 per drawer)
WARNING: Overloading the drawers can affect tbe stability of
- stationary or rotating)
Drawers 15 x 15.5 x 4 inches (38 x 39 x 10 cm)
930 cubic inches per drawer (14,820
l/8 inch NPT fitting
3.5 (9 cm) inch utility post
Three Drawer Storage Accessory:
(for all models with beds
+lOO centimeters of water
IV pole
Gas
manifold with
A
!
Airway Manometer: -20 to
Appendix