Table of Contents
Advertisement
DataTrak Controls and Indicators
DataTrak Controls and Indicators
Key for F
. 8
IG
AA Runaway Limit, in cycles per minute (user settable;
00=OFF)
AB Lower Displacement (user settable)
AC Flow Rate Units (user settable to
[Imperial], oz/min [US], oz/min [Imperial], l/min, or cc/min)
AD LED (fault indicator when lit)
AE Display
PF Prime/Flush Key (Enables Prime/Flush mode. While in
Prime/Flush mode, runaway protection is disabled and the
batch totalizer [BT] will not count.) LED will flash while in
Prime/Flush mode.
RK Reset Key (Resets faults. Press and hold for 3 seconds to
clear the batch totalizer.) Push to toggle between flow rate
and cycle rate. With runaway enabled, push to extend and
retract the solenoid pin.
AE, see details at right
AD
F
. 8. DataTrak Controls and Indicators
IG
22
CF Cycle/Flow Rate
BT Batch Totalizer
GT Grand Totalizer
RT Runaway Toggle (enable/disable)
/min,
gpm [US], gpm
UT E1 Toggle
DT E2 Toggle
ST E5 Toggle
RK
ti11883a
AC
AB
RK
AA
NOTICE
To prevent damage to the softkey buttons, do not
press the buttons with sharp objects such as pens,
plastic cards, or fingernails.
Run Mode
CF
Setup Mode
GT
PF
ti8622b
BT
RT
UT
DT
PF
ti8623b
ST
312799H
Advertisement
Table of Contents
