Advertisement
Advertisement
Table of Contents
Related Manuals for Kalamazoo K16-18
Summary of Contents for Kalamazoo K16-18
- Page 4 CONSULT AN ELECTRICIAN.!!! Follow all safety procedures. SEE ABRASIVE SAFETY SHEET!!! K16-18 uses as standard a manual switch with over loads. Bring incoming AC power to the switch box. Drill/punch switch box to accept a seal tite fitting and connect incoming AC power to L1, L2,L3 on the contactor.
- Page 5 Maintenance- Keep drive V belts tight. ( ½” of squeeze) Do not over tighten. After initial start up and use re-check V belt tension . All bearings are sealed bearings and need no attention. Keep machine and area clean of abrasive dust.
Need help?
Do you have a question about the K16-18 and is the answer not in the manual?
Questions and answers