Connection Terminals Signals; Technical Specifications; Maximum Illumination Distance From Camera At Night; Cleaning Of The Plate - Videx 4202RV Manual

4000 Series
Art. 4202
Audio/video digital front panel

CONNECTION TERMINALS SIGNALS

GND Power supply - ground
+12
Power supply - positive
– BUS connection - negative
L BUS connection - positive
BS
"Busy system" signal
SL
Accessory control signal
NC
Relay out - normally close contact
C
Relay out - common contact
NO Relay out - normally open contact
TRD Trade signal (from Art. 701T)
PTE
Push to exit button
V1
Balanced video signal sync+
V2/V Balanced video signal sync– (V2) or coax video signal
(V) refer to point
GNDV Camera power supply ground & video ground on coax
video system
12T
+12Vdc camera power supply input
Art. 4202 - Installation instructions
F

TECHNICAL SPECIFICATIONS

Memory capacity:
Working voltage:
Max. absorption:
Working temperature:

MAXIMUM ILLUMINATION DISTANCE FROM CAMERA AT NIGHT

The illumination LED's within the camera will
illuminate the visitor when they are within
50 cm of the camera.
Note: The camera supplied may be either
a CCD (With IR illumination) or CMOS (With
white LED illumination) sensor. This difference
does not affect the performance.

CLEANING OF THE PLATE

Use a clean and soft cloth. Use moderate warm water or non-ag-
gressive cleansers.
Do not use:
• abrasive liquids;
• chlorine-based liquids;
• metal cleaning products.
- 5 -
998 users
13 Vdc +/- 10%
about 350 mA
-10 +50° C
MAX 50 cm
66250200 - V2.1 - 15/08/18