Extending Module Connection - 2N Access Unit Installation Manual

2.4 Extending Module Connection

2N Access Unit allows to connect following extending modules:
Keypad
Touch keypad
125 kHz RFID card reader
13.56 MHz RFID card reader
13.56 MHz RFID Card Reader NFC support
Bluetooth & RFID reader 125kHz, 13.56MHz, NFC
Bluetooth & RFID reader 125kHz, secured 13.56MHz, NFC
Touch keypad & RFID reader 125kHz, 13.56MHz, NFC
Touch keypad & RFID reader 125kHz, secured 13.56MHz, NFC
Bluetooth reader
Fingerprint reader
I/O module
Infopanel
Wiegand module
Security relay
Module Bus Interconnection
All the modules that can be connected to
The bus starts on the basic unit and goes over all the modules. The order of modules
on the bus is irrelevant. And it also irrelevant which bus connector on the module is
used as the input and which is used as the output.
The modules include a 220 mm long bus interconnecting cable; Part No. 9155037
Wiegand modules and
cable. These two modules can be hidden inside one of the modules described below
(Infopanel, Keypad, RFID card reader, Bluetooth) and/or placed freely behind a
standalone access unit (in a mounting box, e.g.).
You can order a separate bus cable (
length of 1 m, 3 m or 5 m for remote module installation. Typically, it helps install an
RFID card reader on the opposite side of the wall on which
This long cable can only be used once on the bus.
2N TELEKOMUNIKACE a.s., www.2n.cz
2N Access Unit
Part No. 9155034 I/O modules include an 80 mm long bus
Part Nos. 9155050 9155054 9155055
are interconnected via a bus.
, ,
2N Access Unit is installed.
) of the
87/116