Tire Chains (Traction Devices) - Jeep Compass Operating Information Manual

CAUTION!
Do not use scouring pads, steel wool, a
bristle brush, metal polishes or oven cleaner.
These products may damage the wheel's
protective finish. Such damage is not cov-
ered by the New Vehicle Limited Warranty.
Only car wash soap, MOPAR Wheel Cleaner
or equivalent is recommended.
NOTE:
If you intend parking or storing your vehicle
for an extended period after cleaning the
wheels with wheel cleaner, drive your ve-
hicle for a few minutes before doing so.
Driving the vehicle and applying the brakes
when stopping will reduce the risk of brake
rotor corrosion.
Dark Vapor Or Black Satin Chrome Wheels
CAUTION!
If your vehicle is equipped with Dark Vapor or
Black Satin Chrome wheels DO NOT USE
wheel cleaners, abrasives or polishing com-
pounds. They will permanently damage this
finish and such damage is not covered by the
New Vehicle Limited Warranty. USE ONLY
MILD SOAP AND WATER WITH A SOFT
CLOTH. Used on a regular basis; this is all
that is required to maintain this finish.
198

Tire Chains (Traction Devices)

Use of traction devices require sufficient tire-to-
body clearance. Follow these recommendations
to guard against damage.
• Traction device must be of proper size for the
tire, as recommended by the traction device
manufacturer.
• Install on Front Tires.
• A 215/60R17 96H tire with the use of a
traction device that meets the SAE type
"Class S" specification is recommended.
WARNING!
Using tires of different size and type (M+S,
Snow) between front and rear axles can
cause unpredictable handling. You could lose
control and have a collision.
CAUTION!
To avoid damage to your vehicle or tires,
observe the following precautions:
• Because of restricted traction device clear-
ance between tires and other suspension
components, it is important that only trac-
tion devices in good condition are used.
Broken devices can cause serious dam-
CAUTION! (Continued)
age. Stop the vehicle immediately if noise
occurs that could indicate device break-
age. Remove the damaged parts of the
device before further use.
• Install device as tightly as possible and
then retighten after driving about ½ mile
(0.8 km).
• Do not exceed 30 mph (48 km/h).
• Drive cautiously and avoid severe turns
and large bumps, especially with a loaded
vehicle.
• Do not drive for a prolonged period on dry
pavement.
• Observe the traction device manufacturer's
instructions on the method of installation,
operating speed, and conditions for use.
Always use the suggested operating speed
of the device manufacturer's if it is less
than 30 mph (48 km/h).
• Do not use traction devices on a compact
spare tire.
(Continued)