4) Remove the 12 screws [1], and detach the control-
ler box cover [2].
[1]
[2]
Fig. 2-5
5) Mount the open I/F PCB.
• If the Host Machine Is Not Equipped with a UFR
Board
Remove the 2 screws [1], and detach the face plate [2]
shown in the figure. (You will be using the removed
screws [1] in the next step.)
Fig. 2-6
[1]
[1]
[1]
[2]
[1]
– 4 –
• If the Host Machine Is Equipped with a UFR Board
Remove the 2 screws [1], and detach the UFR board
[2]. (You will be using the removed screws [1] in the
next step.)
Hand over the removed UFR board to
the user for storage.
[2]
Fig. 2-7
6) Using the removed screws, mount the included open
I/F PCB [1] in the slot [2].
[1]
Fig. 2-8
[1]
[2]
Need help?
Do you have a question about the Color Network Printer Unit-D1 and is the answer not in the manual?