Saving The Configuration; Wlp Configuration Example - GO Networks WLP Technical Manual

Wireless lan pico base station
Table of Contents

Advertisement

WPA-Extensible-Authentication-Protocol (WPA-EAP): Using
e.
WPA-EAP key management, the client and the authentication server
authenticate each other using an EAP authentication method, and
the client and server generate a Pairwise Master Key (PMK).
WPA-Pre-shared key (WPA-PSK): Using WPA, the server
f.
generates the PMK dynamically and passes it to the WLP. Using
WPA-PSK, however, you configure a pre-shared key on both the
client and the WLP, and that pre-shared key is used as the PMK.
You can configure the WPA key management in the WLP using the
following command.
configure privacy wpa { { < ssid integer(1-16) > [ passphrase <
passphrase string(8-63)> ] [ key-mngmnt { eap | psk } ] } | { [
gtk-interval < interval integer(30-42949672) > ] [ data-
encryption { tkip | aes } ] [ protocol { wpa1 | wpa2 | wpa2only
} ] [ preauthentication { enable | disable } ] } }

Saving the Configuration

Once you have modified the existing configuration file, you should save it
for future use. To do this, issue the following CLI command:
copy running-configure startup-configure

WLP Configuration Example

WLP > configure ip address 192.168.30.102 255.255.255.0
WLP > configure ip default-gateway 192.168.30.254
WLP > configure interface dot11Radio 0 channel 1
WLP > configure ssid 1 name GO-WLP vlan 0 privacy-method none type
bssid
WLP > configure interface dot11Radio 0 ssid 1 add
WLP > configure interface dot11Radio 0 mode mixed
WLP > configure interface dot11Radio 0 enable
WLP > copy running-config startup-config
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
- Page 24 of 31-

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WLP and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents